Many misconceptions exist about what can help prevent hair loss, one of these being that lack of sexual activity will automatically prevent hair loss. While a proven direct correlation exists between increased frequency of ejaculation and increased levels of DHT, as shown in a recent study by Harvard Medical School , the study suggests that ejaculation frequency may be a sign, rather than a cause, of higher DHT levels.  Another study shows that although sexual arousal and masturbation-induced orgasm increase testosterone concentration around orgasm, they reduce testosterone concentration on average (especially before abstinence) and because about 5% of testosterone is converted to DHT, ejaculation does not elevate DHT levels. 
Hmmmm interesting. Funny you mention it because I was taking gaba not too long ago and it was in a mixture with some other stuff. Anyways, I think it was causing me to wake up kind of uncoordinated and feeling just kind of weird. Dissociative I guess you could say, which makes sense because it’s related to the NMDA receptors somehow I think. It supposedly “can’t” cross the blood brain barrier, at least this is repeated despite the fact that it can and does, it’s just an unreliable mechanism in which it does. Low levels of gaba were insinuated to absorb more in the brain also. I didn’t have this issue as if I took the full 750 mg I felt very strange consistently and none of the other supplements in the mixture would seem to do this.
The DHT22 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old.
Simply connect the first pin on the left to 3-5V power, the second pin to your data input pin and the right most pin to ground. Although it uses a single-wire to send data it is not Dallas One Wire compatible! If you want multiple sensors, each one must have its own data pin! We have written an Arduino library with example code
Compared to the DHT11 , this sensor is more precise, more accurate and works in a bigger range of temperature/humidity, but its larger and more expensive
Comes with a - 10K resistor, which you will want to use as a pullup from the data pin to VCC.